Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes Cisco IOS Release 12.2(44)SE1 and later

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later

464831-005

Documentation Updates

System Messages Guide

These are the documentation updates for the system modesties guide:

• New System Messages, page 25

• Changed System Messages, page 26

New System Messages

These system messages have been added.

Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on

[chars]

Explanation The client MAC address could not be added to the MAC address table because the

hardware memory is full or the address is a secure address on another port. [enet] is the supplicant

MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is

enabled.

Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.

If the client address is on another port, manually remove it from that port.

Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans

Explanation The interface has been added to all VLANs. [chars] is the added interface.

Recommended Action No action is required.

Error Message SPANTREE-6-PORTDEL_ALL_VLANS: [chars] deleted from all Vlans

Explanation The interface has been deleted from all VLANs. [chars] is the deleted interface.

Recommended Action No action is required.

Error Message SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to [chars].

Explanation The VLAN Trunking Protocol (VTP) domain name was changed through the

configuration to the name specified in the message. [chars] is the changed domain name.

Recommended Action No action is required.

Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.

Explanation The system has shut down the specified interface because too many hosts have requested

access to that interface. [chars] is the interface name.

Recommended Action To enable the interface, remove the excess hosts, and enter the no shutdown

interface configuration command.