Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(46)SE

501396-001

Open Caveats

These system messages also appear:

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/network-confg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/cisconet.cfg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/switch-confg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/ciscortr.cfg) failed

These messages are for information only. There is no problem with the switch operation.

Because the switch automatically configures the service config global configuration command, it is

in the switch startup-config file when you save the running-config file. This command runs every

time the switch is restarted, even if a config.text configuration file is in the switch flash memory.

The workaround is to prevent these messages from being generated. To do this, enter the switch

configuration mode, and issue the no service config command. Save the configuration to flash by

using the copy running-config to startup-config command. The preceding error and system

messages no longer appear and do not appear when the switch is restarted.

• CSCsd86177

When you remove and reconfigure a loopback interface, it does not appear in the ifTable.

The workaround is to reload the switch.

• CSCse03859

If the switch is in VTP server mode and VLANs with IDs greater than 255 (256 and above) are

created, DHCP snooping does not work properly on these VLANs.

The workaround is to put the switch in VTP transparent mode before creating the VLANs.

• CSCso96778

When you use the ipv6 address dhcp interface configuration command on an interface that is

configured in router mode, other addresses on the prefix associated with the new address might not

be accessible.

The workaround is to use the ipv6 address dhcp interface configuration command on an interface

that is configured in host mode, or configure a static route to the prefix through the interface.

Open HP Caveats

These are the HP severity 2 open caveats for this release:

• rQm 263546

Disconnecting the cable from the console port does not end a Telnet session. If you are in privileged

EXEC mode when you remove the cable, the next session that is started on the console port will also

be in privileged EXEC mode.

The workaround is to end the session before you remove the cable.

• rQm 266129

If you power on a switch that does not have a config.txt file (the factory default file) and leave the

switch on for few hours, the switch console appears to be stalled during setup.

The workaround is to reload the switch before you continue to configure it.