Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(46)SE

501396-001

Documentation Updates

• Enter the shutdown interface configuration command followed by the no shutdown interface

configuration command to restart the port.

System Messages Guide

These are the documentation updates for the system modesties guide:

• New System Messages, page 17

• Changed System Messages, page 19

New System Messages

These system messages have been added.

Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on

[chars]

Explanation

The client MAC address could not be added to the MAC address table because the

hardware memory is full or the address is a secure address on another port. [enet] is the supplicant

MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is

enabled.

Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.

If the client address is on another port, manually remove it from that port.

Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]

Explanation

The switch cannot create the specified managed object. [chars] is the object name.

Recommended Action No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]

informing virtual switches of dual-active: new active id [enet], old id [enet]

Explanation

Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,

which means that all virtual switches are in a dual-active scenario. The interface is informing virtual

switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first

[enet] is the new active ID. The second [enet] is the ID that it replaces.

Recommended Action No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]

registry

Explanation

The switch could not add a function to the registry. [chars] is the registry name.

Recommended Action No action is required.