Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-class Release Notes, Cisco IOS Release 12.2(50)SE and later

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(50)SE and later

515765-002

Important Notes

Cisco IOS Notes

These notes apply to Cisco IOS software:

• Cisco IOS Release 12.2(40)SE and later

If the switch has interfaces with automatic QoS for voice over IP (VoIP) configured and you upgrade

the switch software to Cisco IOS Release 12.2(40)SE (or later), when you enter the auto qos voip

cisco-phone interface configuration command on another interface, you might see this message:

AutoQoS Error: ciscophone input service policy was not properly applied

policy map AutoQoS-Police-CiscoPhone not configured

If this happens, enter the no auto qos voip cisco-phone interface command on all interface with this

configuration to delete it. Then enter the auto qos voip cisco-phone command on each of these

interfaces to reapply the configuration.

Device Manager Notes

These notes apply to the device manager:

• We recommend that you use this browser setting to display the device manager from Microsoft Internet

Explorer in the least amount of time.

From Microsoft Internet Explorer:

1. Choose Tool s > Internet Options.

2. Click Settings in the “Temporary Internet files” area.

3. From the Settings window, choose Automatically.

4. Click OK.

5. Click OK to exit the Internet Options window.

• The HTTP server interface must be enabled to display the device manager. By default, the HTTP

server is enabled on the switch. Use the show running-config privileged EXEC command to see if

the HTTP server is enabled or disabled.

If you are not using the default method of authentication (the enable password), you need to

configure the HTTP server interface with the method of authentication used on the switch

Beginning in privileged EXEC mode, follow these steps to configure the HTTP server interface:

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

ip http authentication {aaa | enable |

local}

Configure the HTTP server interface for the type of authentication that

you want to use.

• aaa—Enable the authentication, authorization, and accounting feature.

You must enter the aaa new-model interface configuration command

for the aaa keyword to appear.

• enable—Enable password, which is the default method of HTTP

server user authentication, is used.

• local—Local user database, as defined on the Cisco router or access

server, is used.