Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-class Release Notes, Cisco IOS Release 12.2(50)SE and later

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(50)SE and later

515765-002

Resolved Caveats

• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE3” section on page 15

• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE2” section on page 16

• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE1” section on page 16

• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE” section on page 16

Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE3

• CSCso57496

A switch no longer fails when you enter the configure replace privileged EXEC command, and a

banner is already present in the switch configuration.

• CSCsq51052

The output of the show ip ssh privileged EXEC command no longer displays SSH Enabled -

version

2.99. Instead, a correct SSH version (1.5, 1.99 or 2.0) now appears.

• CSCsx49718

Re-authentication now occurs on a port under these conditions:

–

The port is in single-host mode.

–

The port is configured with the authentication event no-response action authorize vlan

vlan-number command.

–

An EAPOL start packet is sent to the port.

• CSCsy72669

If a link failure occurs on a secondary edge port, preemption now occurs after the link comes up.

• CSCsz12381

When open1x authentication and MAC authentication bypass are enabled on a port, an IP phone is

connected to the port, and DHCP snooping is enabled on the switch, DHCP traffic is now forwarded

on the voice VLAN before open 1x authentication times out and the switch uses MAC authentication

bypass to authorize the port.

• CSCsz13490

The switch no longer reloads when you enter several key strokes while in interface-range

configuration mode.

• CSCsz79652

A memory leak no longer occurs when Cisco Network Assistant is polling the switch and the ip http

server or ip http-secure-server global configuration command is enabled.

• CSCta32597

A switch no longer fails when a host moves from a dynamically assigned VLAN to a configured

VLAN.

• CSCta36155

A switch configured with 802.1x and port security on the same ports no longer might inappropriately

put the ports into an error-disabled state.