Manualshelf

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-class Release Notes, Cisco IOS Release 12.2(50)SE and later

ManualsBrandsHP ManualsComputer AccessoriesCisco BLp-Class Ethernet Switch
11121314151617181920
19
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(50)SE and later
515765-002
Documentation Updates
System Messages Guide
These are the documentation updates for the system modesties guide:
• New System Messages, page 19
• Changed System Messages, page 21
New System Messages
These system messages have been added.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, manually remove it from that port.
Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation The switch cannot create the specified managed object. [chars] is the object name.
Recommended Action No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]
informing virtual switches of dual-active: new active id [enet], old id [enet]
Explanation Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,
which means that all virtual switches are in a dual-active scenario. The interface is informing virtual
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first
[enet] is the new active ID. The second [enet] is the ID that it replaces.
Recommended Action No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation The switch could not add a function to the registry. [chars] is the registry name.
Recommended Action No action is required.