Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-class Release Notes, Cisco IOS Release 12.2(50)SE and later

22
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(50)SE and later
515765-002
Related Documentation
Error Message %VQPCLIENT-2-PROCFAIL: Could not create process for VQP. Quitting
Error Message %VQPCLIENT-7-RECONF: Reconfirming VMPS responses
Error Message %VQPCLIENT-2-SHUTDOWN: Interface [chars] shutdown by VMPS
Error Message %VQPCLIENT-3-THROTTLE: Throttling VLAN change on [chars]
Related Documentation
These documents provide complete information about the switch and are available from the HP web site:
http://www.hp.com/support
• Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes
(part number 383623-001)
• Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Software Configuration Guide
(part number 380261-001)
• Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class System Message Guide
(part number 380260-001)
• Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide
(part number 380264-001)
• Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Quick Setup Instructions
(part number 380263-001)
• Cisco Small Form-Factor Pluggable Modules Installation Instructions (part number 380-263-001)
• HP BladeSystem p-Class SAN Connectivity Kit Quick Setup Instructions For Installing in Cisco
Gigabit Ethernet Switch Module (part number 380262-001)
Cisco IOS Release 12.2 documentation is available at
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/index.html
Technical support
Before you contact HP
Be sure to have the following information available before you call HP:
• Technical support registration number (if applicable)
• Product serial number
• Product model name and number
• Applicable error messages
• Add-on boards or hardware