Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Release Notes, Cisco IOS Release 12.2(25)SED
Table Of Contents
- Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Release Notes, Cisco IOS Release 12.2(25)SED
- November 2005
- Contents
- System requirements
- Upgrading the switch software
- Installation notes
- Major features
- Minimum Cisco IOS release for major features
- Limitations and restrictions
- Device manager notes
- VLAN interfaces and MAC addresses
- Documentation notes
- Open caveats
- Resolved caveats
- Related documentation
- Obtaining technical support
11
Documentation notes
This section describes documentation notes related to this Cisco IOS release.
References to Cisco IOS release number
These documents refer to Release 12.2(25)SE. The correct release is Release 12.2(25)SE1 and later.
• Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide, Cisco
IOS Release 12.2(25)SE
• Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Command Reference Guide, Cisco IOS
Release 12.2(25)SE
• Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide, Cisco IOS
Release 12.2(25)SE
Open caveats
These sections describe the open caveats with possible unexpected activity in this software release:
• Open Cisco IOS caveats
• Open HP caveats
• Open device manager caveats
Open Cisco IOS caveats
These severity 3 Cisco IOS configuration caveats apply to the CGESM switch:
• CSCee12496
When a switch is in interface range configuration mode and you enter the ip arp inspection trust
command to set a range of ports to trusted mode, if some of those ports are members of a channel-group
this error message might appear:
%PM-3-INTERNALERROR: Port Manager Internal Software Error (pd->physicalPort
&& pd->agPort == NULL: ../switch/pm/pm_port.c: 3865: pm_port_want_to_bundle)
There is no workaround.
• CSCee22376
When a switch using SNMP version 3 is configured with the encrypted option and password, the switch
reloads when the MIB object usmUserAuthKeyChange is set.
The workaround is to configure the switch without the encrypted option. (For example, snmp-server
user username groupname v3 auth md5 password.)
• CSCee93822
When port security is enabled on an interface in restricted mode and the switchport block unicast
interface command is entered for that interface, MAC addresses are incorrectly forwarded when they
should be blocked.
The workaround is to enter the no switchport block unicast interface configuration command
for that specific interface.
• CSCeg04311
When you power on or restart a switch without a config.text file in flash memory, the switch tries to get
configuration files from a TFTP server. If the configuration files are not found, the switch automatically
configures the service config global configuration command, and the switch continues to search for
the expected configuration files.
If the service config command does not find the configuration files, these error messages appear:
%Error opening tftp://255.255.255.255/network-confg (Timed out)
%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)
%Error opening tftp://255.255.255.255/router-confg (Timed out)
%Error opening tftp://255.255.255.255/ciscortr.cfg (Timed out)
These system messages also appear:
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/network-confg) failed
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/cisconet.cfg) failed