Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Release Notes, Cisco IOS Release 12.2(25)SED

13
Open HP caveats
These are the HP severity 2 open caveats for this release:
• rQm 263546
Disconnecting the cable from the console port does not end a Telnet session. If you are in privileged EXEC
mode when you remove the cable, the next session that is started on the console port will also be in
privileged EXEC mode.
The workaround is to end the session before you remove the cable.
• rQm 266129
If you power on a switch that does not have a config.txt file (the factory default file) and leave the switch on
for few hours, the switch console appears to be stalled during setup.
The workaround is to reload the switch before you continue to configure it.
Open device manager caveats
These are the severity 3 device manager caveats for this release:
• CSCef45718
When you are prompted to accept the security certificate and you click No, you only see a blank screen,
and the device manager does not launch.
The workaround is to click Yes when you are prompted to accept the certificate.
• CSCef94061
If you enter the letter i by itself in the port description, the VLAN status column displays i; this only occurs
when you are using device manager through Netscape 7.1.
The workaround is to run device manager through Internet Explorer if you must enter a port description with
only the value i.
Resolved caveats
These caveats were resolved in this release for the CGESM switch:
• CSCed23767
The switchport port-security aging time 0 interface configuration command now disables the
aging time.
• CSCed37222
Sticky addresses are no longer lost during a master switchover.
• CSCed46781
When you configured the dot1x timeout tx-period interface configuration command as greater than
the dot1x timeout quiet-period interface configuration command setting, users were not
authenticated into the guest VLAN when 802.1x authentication failed.
• CSCed87243
If the VTP password is configured but the VTP domain name is not configured, and if the switch reloads
twice, the switch now retains the VLAN information.
• CSCee08109
If a port-based ACL (PACL) is applied to an 802.1x-enabled port and the client is then disconnected from
that port, the PACL is removed from the port.
• CSCee30022
This message no longer appears when you add an aggregate policer to a policy map:
BAD policymap info 9999999
• CSCee30090
This message no longer appears when you modify a policer or remove an aggregate policer:
Download failed for <class-name>
Bad policymap info.
• CSCee30129
When you add an aggregate policer to a policy-map class, the aggregate policer is no longer also added
to another policy class within the same policy.
• CSCee37070