Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide

6-34

380261-003

Chapter 6 Configuring IEEE 802.1x Port-Based Authentication

Configuring IEEE 802.1x Authentication

Beginning in privileged EXEC mode, follow these steps to configure the port as a critical port and enable

the inaccessible authentication bypass feature. This procedure is optional.

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

radius-server dead-criteria time time

tries tries

(Optional) Set the conditions that are used to decide when a RADIUS

server is considered unavailable or dead.

The range for time is from 1 to 120 seconds. The switch dynamically

determines the default seconds value that is 10 to 60 seconds.

The range for tries is from 1 to 100. The switch dynamically determines

the default tries parameter that is 10 to 100.

Step 3

radius-server deadtime minutes (Optional) Set the number of minutes that a RADIUS server is not sent

requests. The range is from 0 to 1440 minutes (24 hours). The default is

0 minutes.