Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide

6-42

380261-003

Chapter 6 Configuring IEEE 802.1x Port-Based Authentication

Displaying IEEE 802.1x Statistics and Status

Resetting the IEEE 802.1x Authentication Configuration to the Default Values

Beginning in privileged EXEC mode, follow these steps to reset the IEEE 802.1x authentication

configuration to the default values. This procedure is optional.

Displaying IEEE 802.1x Statistics and Status

To display IEEE 802.1x statistics for all ports, use the show dot1x all statistics privileged EXEC

command. To display IEEE 802.1x statistics for a specific port, use the show dot1x statistics interface

interface-id privileged EXEC command.

To display the IEEE 802.1x administrative and operational status for the switch, use the show dot1x all

[details | statistics | summary] privileged EXEC command. To display the IEEE 802.1x administrative

and operational status for a specific port, use the show dot1x interface interface-id privileged EXEC

command.

For detailed information about the fields in these displays, see the command reference for this release.

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

interface interface-id Enter interface configuration mode, and specify the port to be configured.

Step 3

dot1x default Reset the IEEE 802.1x parameters to the default values.

Step 4

end Return to privileged EXEC mode.

Step 5

show dot1x interface interface-id Verify your entries.

Step 6

copy running-config startup-config (Optional) Save your entries in the configuration file.