Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide

1-11
Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide
380261-003
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• VLANs
– Default VLAN is VLAN 1. For more information, see Chapter 9, “Configuring VLANs.”
– VLAN trunking setting is dynamic auto (DTP). For more information, see Chapter 9,
“Configuring VLANs.”
– Trunk encapsulation is negotiate. For more information, see Chapter 9, “Configuring VLANs.”
– VTP mode is server. For more information, see Chapter 10, “Configuring VTP.”
– VTP version is Version 1. For more information, see Chapter 10, “Configuring VTP.”
– Voice VLAN is disabled. For more information, see Chapter 11, “Configuring Voice VLAN.”
• STP, PVST+ is enabled on VLAN 1. For more information, see Chapter 12, “Configuring STP.”
• MSTP is disabled. For more information, see Chapter 13, “Configuring MSTP.”
• Optional spanning-tree features are disabled. For more information, see Chapter 14, “Configuring
Optional Spanning-Tree Features.”
• Flex Links are not configured. For more information, see Chapter 15, “Configuring Flex Links and
the MAC Address-Table Move Update Feature.”
• DHCP snooping is disabled. The DHCP snooping information option is enabled. For more
information, see Chapter 16, “Configuring DHCP Features.”
• IGMP snooping is enabled. No IGMP filters are applied. For more information, see Chapter 17,
“Configuring IGMP Snooping and MVR.”
• IGMP throttling setting is deny. For more information, see Chapter 17, “Configuring IGMP
Snooping and MVR.”
• The IGMP snooping querier feature is disabled. For more information, see Chapter 17, “Configuring
IGMP Snooping and MVR.”
• MVR is disabled. For more information, see Chapter 17, “Configuring IGMP Snooping and MVR.”
• Port-based traffic
– Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 18, “Configuring Port-Based Traffic Control.”
– No protected ports are defined. For more information, see Chapter 18, “Configuring Port-Based
Traffic Control.”
– Unicast and multicast traffic flooding is not blocked. For more information, see Chapter 18,
“Configuring Port-Based Traffic Control.”
– No secure ports are configured. For more information, see Chapter 18, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 19, “Configuring CDP.”
• UDLD is disabled. For more information, see Chapter 21, “Configuring UDLD.”
• SPAN and RSPAN are disabled. For more information, see Chapter 22, “Configuring SPAN and
RSPAN.”
• RMON is disabled. For more information, see Chapter 23, “Configuring RMON.”
• Syslog messages are enabled and appear on the console. For more information, see Chapter 24,
“Configuring System Message Logging.”
• SNMP is enabled (Version 1). For more information, see Chapter 25, “Configuring SNMP.”
• No ACLs are configured. For more information, see Chapter 26, “Configuring Network Security
with ACLs.”