Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-4
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
ACLMGR Messages
Error Message ACLMGR-3-INSERTFAIL: Insert of access-map [chars] #[dec] into [chars]
label [dec] failed.
Explanation This message means that the system ran out of CPU memory when trying to merge
sections of an access map. The first [chars] is the map name, and the second [chars] is the direction
in which the map was applied. The first [dec] is the entry number, and the second [dec] is the label
number.
Recommended Action Reduce other system activity to ease memory demands. For example, remove
any ACLs that have been defined but not used. Use simpler ACLs with fewer access-control entries
(ACEs). Use fewer VLANs, and remove any unneeded VLANs from the VLAN database.
Error Message ACLMGR-3-INTTABLE: Not in truth table: VLMAP [dec] RACL [dec] Mcb [dec]
Feat [dec].
Explanation This message means that an unrecoverable software error occurred while trying to
merge the configured input features. [dec] are internal action codes.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message ACLMGR-3-MAXRECURSION: Too many ([dec]) levels of recursion while
merging ACLs (code [dec]).
Explanation This message means that the configuration is too complicated for the platform-specific
ACL merge code to support. The most likely cause is too many separate access lists in a single
VLAN map or policy map. The first [dec] is the number of levels of recursion. The second [dec] is
an internal code number of the merge stage that encountered the problem.
Recommended Action Reduce the number of IP or MAC access lists (considered separately) in any
one VLAN or policy map to fewer than the number of levels reported by this log message.
Error Message ACLMGR-3-MERGEFAIL: [chars] ACL merge error [dec] ([chars]) on [chars]
label [dec].
Explanation This message means that the ACL manager could not complete the merge of the
configured features into a form suitable for loading into the hardware. Packets potentially affected
by this feature will be sent to the CPU for processing. The most likely cause is specifying an ACL
that is too large or too complex for the system. The first [chars] is the ACL-type error (ip or mac),
the first [dec] is the error code, the second [chars] is the message string for the preceding error code,
the second [dec] is the label number, and the third [chars] is either input or output.
Recommended Action Specify a smaller and less complicated configuration.