Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-6
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
BSPATCH Messages
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.
Explanation This message means that the ACL manager could not load the complete configuration
into the hardware, so some features will be applied in the software. Some or all of the packets in a
VLAN are forwarded by the CPU. Multicast packets might be dropped entirely instead of being
forwarded. [chars] is the direction (input or output), and [dec] is the label number.
Recommended Action Use a simpler configuration. Use the same ACLs on multiple interfaces, if
possible.
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning: Flexlink VLB is not allowed
on non-trunk ports. Please configure [chars] to be a trunk port.
Explanation This message means that Flex Link VLAN load-balancing (VLB) detects a nontrunk
port. [chars] is the interface name.
Recommended Action Configure the interface to operate in trunking mode.
BSPATCH Messages
This section contains boot loader patch messages.
Error Message BSPATCH-1-RELOAD: System will reboot to activate newly patched Boot
Loader.
Explanation This message means that the switch automatically reboots after the boot loader is
patched.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, contact HP technical
support and provide the representative with the gathered information. For more information about
the online tools and about contacting HP, see the
“Error Message Traceback Reports” section on
page 1-5.
Error Message BSPATCH-1-PATCHED: Boot Loader patch ([chars]) installed.
Explanation This message means that a boot loader patch installed successfully. [chars] is the
SDRAM refresh timer register setting.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, contact HP technical
support and provide the representative with the gathered information. For more information about
the online tools and about contacting HP, see the
“Error Message Traceback Reports” section on
page 1-5.