Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-8

Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide

380260-004

Chapter 2 Message and Recovery Procedures

CMP Messages

This section contains the Cluster Membership Protocol (CMP) messages.

Error Message CMP-4-MEM_CMPIP_ADDR_CONFLICT: Conflict with CMP IP address

[IP_address], Reissuing a new CMP IP address to member [dec]

Explanation This message means that the cluster commander found a conflict with the assigned CMP

IP address of the member. A new unique CMP IP address is assigned to the member. [dec] is the

member number.

Recommended Action This is only a warning message. The commander has already assigned the

cluster member a new unique address. Clear any open TCP connections on the member by using

clear tcp privileged EXEC command.

Error Message CMP-5-ADD: The Device is added to the cluster (Cluster Name: [chars],

CMDR IP Address [IP_address]).

Explanation This message means that the device is added to the cluster. [chars] is the cluster name,

and [

IP_address] is the Internet address of the command switch.

Recommended Action No action is required.

Error Message CMP-5-MEMBER_CONFIG_UPDATE: Received member configuration from member

[dec].

Explanation This message means that the active or standby command switch received a member

configuration. [dec] is the member number of the sender.

Recommended Action No action is required.

Error Message CMP-5-MGMT_VLAN_CHNG: The management vlan has been changed to [dec].

Explanation This message means that the management VLAN has changed. [dec] is the new

management VLAN ID.

Recommended Action No action is required.

Error Message CMP-5-NBR_UPD_SIZE_TOO_BIG: Number of neighbors in neighbor update is

[int], maximum number of neighbors allowed in neighbor update is [int].

Explanation This message means that the number of cluster neighbors in the clustering neighbor

update packet exceeds the number of neighbors supported by the clustering module. The first [int]

is the new number of neighbors, and the second [int] the maximum number of neighbors.

Recommended Action No action is required.