Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-9
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
DHCP_SNOOPING Messages
Error Message CMP-5-REMOVE: The Device is removed from the cluster (Cluster Name:
[chars]).
Explanation This message means that the device is removed from the cluster. [chars] is the cluster
name.
Recommended Action No action is required.
DHCP_SNOOPING Messages
This section contains the DHCP snooping messages.
Error Message DHCP_SNOOPING-3-DHCP_SNOOPING_INTERNAL_ERROR: DHCP Snooping internal
error, [chars].
Explanation This message means that a software sanity check failed in the DHCP snooping process.
[chars] is the error.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed. [chars].
Explanation This message means that the DHCP snooping binding transfer process failed. [chars] is
the reason the process failed.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED_N: DHCP snooping binding
transfer failed ([dec]). [chars].
Explanation This message means that the DHCP snooping binding transfer process failed. [dec] is
the number of times the process failed, and [chars] is the reason the process failed. This message is
rate-limited.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_ERRDISABLE_WARNING: DHCP Snooping
received [dec] DHCP packets on interface [chars].
Explanation This message means that the switch detected a DHCP packet rate-limit violation on the
specified interface and put the interface in the error-disabled state. [dec] is the number of DCHP
packets, and [chars] is the interface.
Recommended Action No action is required.