Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-12
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
DOT1X Messages
Error Message DHCP_SNOOPING-6-VLAN_NOT_SUPPORTED: Vlan not supported. [dec] bindings
ignored.
Explanation This message means that the specified number of bindings were ignored when the
switch read the database file because the VLAN is no longer configured on the switch. [dec] is the
number of bindings that the switch ignores.
Recommended Action No action required.
DOT1X Messages
This section contains the IEEE 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X
action.
Explanation This message means that the system memory is not sufficient to perform the
IEEE
802.1x authentication.
Recommended Action Reduce other system activity to reduce memory demands.
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Explanation This message means that the system did not start the IEEE 802.1x process.
Recommended Action Restart the IEEE 802.1x process by entering the dot1x system-auth-control
global configuration command. If this message recurs, reload the device.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Explanation This message means that the IEEE 802.1x process cannot operate because of an internal
system error.
Recommended Action Reload the device.
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
Explanation This message means that the IEEE 802.1x interface parameter is out of the specified
range or is invalid. [chars] is the interface.
Recommended Action Refer to the CLI help documentation to determine the valid IEEE 802.1x
parameters.