Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-14
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
DTP Messages
Error Message DOT1X_SWITCH-5-ERR_VLAN_ON_ROUTED_PORT: Dot1x cannot assign a VLAN
[dec] to a routed port [chars]
Explanation This message means that an attempt was made to assign a VLAN to a supplicant on a
routed port, which is not allowed. [dec] is the VLAN ID and [chars] is the port.
Recommended Action Either disable the VLAN assignment, or change the port type to a nonrouted
port.
Error Message DOT1X_SWITCH-5-ERR_VLAN_ROUTED_PORT: Attempt to assign VLAN [dec] to
routed 802.1x port [chars]
Explanation This message means that an attempt was made to assign a VLAN to a routed IEEE
802.1x port, which is not allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action Change the mode of the port so that it is no longer a routed port, or change the
configuration so that no VLAN is assigned.
DTP Messages
This section contains the Dynamic Trunking Protocol (DTP) messages.
Error Message DTP-4-MEM_UNAVAIL: Memory was not available to perform the trunk
negotiation action.
Explanation This message means that the system cannot negotiate trunks because of a lack of
memory.
Recommended Action Reduce other system activity to ease memory demands.
Error Message DTP-4-TMRERR: An internal timer error occurred when trunking on
interface [chars].
Explanation This message means that a timer used by the trunking protocol unexpectedly expired.
[chars] is the trunked interface.
Recommended Action This problem is corrected internally and has no long-term ramifications.
However, if more problems with trunking occur, reload the switch by using the reload privileged
EXEC command.
Error Message DTP-4-UNKN_ERR: An unknown operational error occurred.
Explanation This message means that the system cannot negotiate trunks because an internal
operation generated an unexpected error.
Recommended Action Reload the switch by using the reload privileged EXEC command.