Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-16

Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide

380260-004

Chapter 2 Message and Recovery Procedures

DWL Messages

This section contains the down-when-looped (DWL) message. This feature disables an interface when a

loopback is detected.

Error Message DWL-3-LOOP_BACK_DETECTED: Loop-back detected on [chars].

Explanation This message means that there is a loopback on the specified port. The cause might be

a Token-Ring Type-1 cable connected to the port or a misconfiguration in the network. [chars] is the

port.

Recommended Action Correct the problem that is causing the loopback condition. Then enter the

shutdown and the no shutdown interface configuration commands.

EC Messages

This section contains the EtherChannel, Link Aggregation Control Protocol (LACP), and Port

Aggregation Protocol (PAgP) messages.

Error Message EC-4-NOMEM: Not enough memory available for [chars].

Explanation This message means that either the LACP or the PAgP EtherChannel could not obtain

the memory it needed to initialize the required data structures. [chars] is the data structure name.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the

“Error Message Traceback Reports” section on page 1-5.

Error Message EC-5-BUNDLE: Interface [chars] joined port-channel [chars].

Explanation This message means that the listed interface joined the specified EtherChannel. The first

[chars] is the physical interface, and the second [chars] is the EtherChannel interface.

Recommended Action No action is required.

Error Message EC-5-CANNOT_ALLOCATE_AGGREGATOR: Aggregator limit reached, cannot

allocate aggregator for group [dec].

Explanation This message means that a new aggregator cannot be allocated in the group. [dec] is the

affected group.

Recommended Action Change the port attributes of the ports in the group so that they match and join

the same aggregator.