Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-23
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
GBIC_SECURITY_CRYPT Messages
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message GBIC_SECURITY-6-SFP_INSERTED: Transceiver SFP [chars] module inserted
in [chars]
Explanation This message means that the online insertion and removal (OIR) facility detected a
newly inserted transceiver module for the interface specified in the message. The first [chars] is the
module, and the second [chars] is the interface.
Recommended Action No action is required.
Error Message GBIC_SECURITY-6-SFP_REMOVED: Transceiver SFP [chars] module removed
from [chars]
Explanation This message means that the OIR facility detected the removal of a transceiver module
from the interface specified in the message. The first [chars] is the module, and the second [chars]
is the interface.
Recommended Action No action is required.
GBIC_SECURITY_CRYPT Messages
This section contains the Cisco GBIC module and SFP module security messages. The switch recognizes
the module as a Cisco module but identifies another problem with it.
Note The switch supports SFP modules and does not support GBIC modules. Although the error message text
refers to GBIC interfaces and modules, the messages from the switch actually refer to the SFP module
interfaces and modules.
Error Message GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for
GBIC interface [chars].
Explanation This message means that the SFP module was identified as a Cisco SFP module, but the
system could not verify its identity. [chars] is the interface in which the module is installed.
Recommended Action Check the list of supported SFP modules for this version of the system
software. An upgrade might be required for newer modules. Otherwise, verify that the module was
obtained from Cisco or from a supported vendor.