Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-29
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
MAC_LIMIT Messages
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Explanation This message means that Protocol-Independent Multicast (PIM) is disabled on the
switch virtual interface (SVI), and the IGMP querier function is now enabled. [dec] is the VLAN ID.
Recommended Action No action is required.
Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because IGMP snooping is no longer disabled.
Explanation This message means that IGMP snooping was enabled. As a result, the IGMP querier
function is now enabled. [dec] is the VLAN ID.
Recommended Action No action is required.
MAC_LIMIT Messages
This section contains the MAC_LIMIT messages, which describe the entries in the MAC address table.
Error Message MAC_LIMIT-4-DROP: Vlan [dec] with Configured limit = [dec] has
currently [dec] Entries.
Explanation This message means that the number of MAC address table entries for a VLAN is less
than or equal to the maximum number allowed. The first [dec] is the VLAN ID, the second [dec] is
the maximum number of MAC address entries, and the third [dec] is the number of entries in the
MAC address table.
Recommended Action Contact your network administrator to configure this action.
Error Message MAC_LIMIT-4-ENFORCE: Enforcing limit on Vlan [dec] with Configured
limit = [dec].
Explanation This message means that the number of MAC address entries for the VLAN exceeds the
maximum number allowed. The configured action is to limit the number of entries to the maximum
allowed. The first [dec] is the VLAN ID, and the second [dec] is the maximum number of MAC
address entries.
Recommended Action Contact your network administrator to configure this action.
Error Message MAC_LIMIT-4-EXCEED: Vlan [dec] with Configured limit = [dec] has
currently [dec] Entries.
Explanation This message means that the number of MAC address entries for a VLAN exceeds the
maximum number allowed. The first [dec] is the VLAN ID, the second [dec] is the maximum
number of MAC address entries, and the third [dec] is the number of entries in the MAC address
table.
Recommended Action Contact your network administrator to configure this action.