Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-30
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
MAC_MOVE Messages
MAC_MOVE Messages
This section contains the MAC_MOVE message.
Error Message MAC_MOVE-4-NOTIF: Host [enet] in vlan [dec] is flapping between port
[chars] and port [chars].
Explanation This message means that the host is moving between the specified ports. [enet] is the
Ethernet address of the host, [dec] is the VLAN ID, the first [chars] is the first port, and the second
[chars] is the second port.
Recommended Action Check your network for loops.
PAGP_DUAL_ACTIVE Messages
This section contains Port Aggregation Protocol (PAgP) dual-active detection messages.
Error Message PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation This message means that the switch cannot create the specified managed object. [chars]
is the object name.
Recommended Action No action is required.
Error Message PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars] informing
virtual switches of dual-active: new active id [enet], old id [enet]
Explanation This message means that PAgP received a new active ID on the specified interface,
which means that all virtual switches are in a dual-active scenario. The interface is informing virtual
switches of this, which causes one switch to go into recovery mode. [chars] is the interface, the first
[enet] is the new active ID, and the second [enet] is the ID that it replaces.
Recommended Action No action is required.
Error Message PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation This message means that the switch could not add a function to the registry. [chars] is
the registry name.
Recommended Action No action is required.