Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-33

Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide

380260-004

Chapter 2 Message and Recovery Procedures

PLATFORM_PM Messages

This section contains platform port manager (PM) messages.

Error Message PLATFORM_PM-3-IFCOUNTERROR: Unit number [dec] of interface [chars] is

more than max allowed value of [dec].

Explanation This message means that there are too many interfaces configured for the interface type.

[dec] is the interface count, [chars] is the interface, and [dec] is the maximum number of interfaces.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the

“Error Message Traceback Reports” section on page 1-5.

Error Message PLATFORM_PM-3-INTVLANINUSE: internal vlan-id [dec] allocated for

interface [chars] is still in use.

Explanation This message means that an internal VLAN ID allocated for an interface is still in use.

[dec] is the VLAN ID, and [chars] is the interface.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the

“Error Message Traceback Reports” section on page 1-5.

Error Message PLATFORM_PM-3-NOINTVLAN: internal vlan of interface [chars] is not

active for vlan-id [dec].

Explanation This message means that internal vlan_data is not active for the given VLAN ID. [chars]

is the interface, and [dec] is the VLAN ID.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the

“Error Message Traceback Reports” section on page 1-5.