Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-40
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
PM Messages
Error Message PM-4-INACTIVE: putting [chars] in inactive state because [chars].
Explanation This message means that the port is inactive because the port manager could not create
a virtual port for the switch port and VLAN. The reason for this condition is specified in the error
message. The first [chars] is the interface name, and the second [chars] is the reason.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message PM-4-INT_FAILUP: [chars] failed to come up. No internal VLAN available.
Explanation This message means that the port manager did not allocate an internal VLAN. The
interface cannot be enabled. [chars] is the interface name.
Recommended Action Remove the extended-range VLAN by using the no vlan vlan-id global
configuration command to free up resources.
Error Message PM-4-INT_VLAN_NOTAVAIL: Failed to allocate internal VLAN in Port
Manager.
Explanation This message means that the port manager did not find any available internal VLAN.
Recommended Action Delete some extended-range VLANs created by users, or remove some features
that require internal VLAN allocation. To delete extended-range VLANs, use the no vlan vlan-id
global configuration command.
Error Message PM-4-INVALID_HOST_ACCESS_ENTRY: Invalid Host access entry type ([dec])
is received.
Explanation This message means that an invalid host access entry type was received. The host access
entry should be a configured or a dynamic type. [dec] is the entry type that is received.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message PM-4-LIMITS: The number of vlan-port instances on [chars] exceeded the
recommended limit of [dec].
Explanation This message means that the total number of individual VLAN ports on the module or
the switch has exceeded the recommended limit. VLANs can be counted more than once. If VLAN
1 is carried on ten interfaces, it counts as ten VLAN ports. On some platforms, bundling is also