Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-42
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
PM Messages
Error Message PM-4-TOO_MANY_APP: application ’[chars]’ exceeded registration limit.
Explanation This message means that the port manager detected an invalid request. [chars] is the
application.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message PM-4-UNKNOWN_HOST_ACCESS: Invalid Host access value ([dec]) is
received.
Explanation This message means that the host access table is being accessed with an invalid host
access value. [dec] is the value that is received.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message PM-4-VMPS_CFG: Dynamic access VLAN [dec] same as voice vlan on [chars].
Explanation This message means that the access VLAN ID on the VMPS server is the same as the
voice VLAN ID on the interface. [dec] is the access VLAN ID, and [chars] is the physical interface.
Recommended Action Assign the access VLAN on the VMPS server to a VLAN ID that is different
from the voice VLAN ID.
Error Message PM-6-EXT_VLAN_ADDITION: Extended VLAN is not allowed to be configured
in VTP CLIENT mode.
Explanation This message means that the switch did not add a VLAN in VTP client mode.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section on page 1-5.