Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-43
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
PORT_SECURITY Messages
PORT_SECURITY Messages
This section contains the port security messages.
Error Message PORT_SECURITY-2-PSECURE_VIOLATION:Security violation occurred caused
by MAC [enet] on port [chars].
Explanation This message means that an unauthorized device attempted to connect on a secure port.
[enet] is the MAC address of the unauthorized device, and [chars] is the secure port.
Recommended Action Identify the device that attempted to connect on the secure port. Notify your
network system administrator of this condition.
Error Message PORT_SECURITY-2-PSECURE_VIOLATION_VLAN: Security violation on port
[chars] due to MAC address [enet] on VLAN [dec]
Explanation This message means that an unauthorized device attempted to connect on a secure trunk
port. [chars] is the secure port, [enet] is the MAC address of the unauthorized device, and [dec] is
the VLAN ID.
Recommended Action Identify the device that attempted to connect through the secure trunk port.
Notify your network system administrator of this condition.
Error Message PORT_SECURITY-6-ADDR_REMOVED: Address [dec]:[enet] exists on port
[chars]. It has been removed from port [chars].
Explanation This message means that a routed port is reconfigured as a switch port. The address in
the previous switch configuration conflicts with the information in the running configuration and
has been deleted. [dec]:[enet] is the MAC address of the port, and [chars] is the reconfigured port.
Recommended Action No action is required.
Error Message PORT_SECURITY-6-ADDRESSES_REMOVED: Maximum system secure address count
reached. Some secure addresses configured on port [chars] removed.
Explanation This message means that some configured and sticky MAC addresses on the specified
port were removed from the configuration. The number of secure addresses that the system supports
was exceeded. This condition occurs only during hot swapping or port-mode changes (for example,
when the port is converted from a Layer 3 to a Layer 2 port). [chars] is the port.
Recommended Action No action is required.