Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-44
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message PORT_SECURITY-6-VLAN_FULL: Vlan [dec] on port [chars] has reached its
limit. Address [enet] has been removed.
Explanation This message means that the voice VLAN is the same as the access VLAN. Because the
maximum number of MAC addresses allowed on the access VLAN has been reached, the specified
Ethernet address has been deleted. [dec] is the VLAN ID, [chars] is the port assigned to the voice
VLAN and the access VLAN, and [enet] is the Ethernet address.
Recommended Action No action is required.
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [dec] is no longer allowed on port
[chars]. Its port security configuration has been removed.
Explanation This message means that the VLAN is not allowed on the trunk port and is removed
from the trunk port configuration. [dec] is the VLAN ID, and [chars] is the switch port assigned to
the VLAN.
Recommended Action No action is required.
QOSMGR Messages
This section contains the quality of service (QoS) manager messages.
Error Message QOSMGR-3-FEATURE_NOT_FOUND: Cannot find feature for [chars].
Explanation This message means that an internal software error has occurred. [chars] is the
description of the feature that the software cannot find.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message QOSMGR-3-FILTERTYPE_INVALID: Internal Error Invalid Policy filtertype
[dec].
Explanation This message means that an internal software error has occurred. [dec] is the invalid
filter type identification.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.