Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-48
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for
policymap [chars].
Explanation This message means that the policy-map configuration has exceeded the limitation of
the hardware. You configured more QoS ACL entries than the number specified in the Switch
Database Management (SDM) template. [chars] is the policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS
ACLs.
Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap
[chars].
Explanation This message means that an unsupported match type was entered. Only the
access-group acl-index-or-name, ip dscp dscp-list, and ip precedence ip-precedence-list match
types are supported with the match class-map configuration command. [chars] is the class-map
name.
Recommended Action Reconfigure the class map using only the match access-group, match ip dscp,
and match ip precedence class-map configuration commands within the class map.
Error Message QOSMGR-4-NOT_SUPPORTED: Action ’[chars]’ is not supported for a
policymap attached to output side.
Explanation This message means that a set or trust policy-map class configuration command was
configured in a policy map and attached to an egress interface. A warning message is logged, and
the actions do not take effect. This is a hardware limitation. [chars] is either the set or trust action.
Recommended Action Do not configure a set or trust policy-map class configuration command in a
policy map and attach it to an egress interface. These policy-map actions are supported only on
ingress interfaces.
Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has
exceeded hardware limitation for policymap [chars].
Explanation This message means that the policy-map configuration has exceeded the hardware
limitation. An attempt to configure more policers in all policy maps (by using the police or police
aggregate policy-map class configuration command) than supported by the hardware, which is not
allowed, caused this condition. [chars] is the policy-map name.
Recommended Action Reconfigure the class maps or the policy maps, or delete the policy map from
some interfaces.