Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-53
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
SPANTREE Messages
There could be additional inconsistencies not shown in the message, and the port does not recover
until all these are cleared. To determine which other VLANs have inconsistencies, disable and
re-enable the port. This message appears again and specifies another VLAN with inconsistencies to
be fixed. Repeat this process until all inconsistencies on all VLANs are cleared.
Error Message SPANTREE-2-PVSTSIM_OK: PVST Simulation inconsistency cleared on port
[chars].
Explanation This message means that the specified interface is no longer receiving PVST BPDUs
advertising information that is inconsistent with the CIST port information. The PVST simulation
inconsistency is cleared, and the interface returns to normal operation. [chars] is the port.
Recommended Action No action is required.
Error Message SPANTREE-2-RECV_1Q_NON_1QTRUNK: Received 802.1Q BPDU on non 802.1Q
trunk [chars] [chars].
Explanation This message means that the interface that received a Shared Spanning Tree Protocol
(SSTP) BPDU was in trunk mode but was not using IEEE 802.1Q encapsulation. The first [chars] is
the interface, and the second [chars] is the VLAN.
Recommended Action Verify that the configuration and operational state of the listed interface and
that of the interface to which it is connected are in the same mode (access or trunk). If the mode is
trunk, verify that both interfaces have the same encapsulation (ISL or IEEE 802.1Q). If the
encapsulation types are different, use the switchport trunk encapsulation interface configuration
command to make them consistent. When the encapsulation is consistent, spanning tree
automatically unblocks the interface.
Error Message SPANTREE-2-RECV_BAD_TLV: Received SSTP BPDU with bad TLV on [chars]
[chars].
Explanation This message means that the listed interface received an SSTP BPDU without the
VLAN ID tag. The BPDU is discarded. The first [chars] is the interface, and the second [chars] is
the VLAN that received the SSTP BPDU.
Recommended Action If this message recurs, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use
the Bug Toolkit to look for similar reported problems. If you still require assistance, contact HP
technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting HP, see the
“Error Message Traceback
Reports” section on page 1-5.