Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-56
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
SPANTREE Messages
Error Message SPANTREE-4-PORT_NOT_FORWARDING: [chars] [chars] [chars] [chars].
Explanation This message means that a port-not-forwarding alarm has been set or cleared. The first
[chars] is the mode, and the second [chars] is the severity. The third [chars] is the interface name,
and the fourth [chars] is the alarm string.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message SPANTREE-5-EXTENDED_SYSID: Extended SysId [chars] for type [chars].
Explanation This message means that the extended system ID feature is either enabled or disabled
for the given type of spanning tree. If enabled, the spanning-tree instance identifier is stored in the
lower portion of the bridge ID priority field and limits the allowed values for the bridge priority from
0 to 61440, in increments of 4096. If disabled, the bridge ID priority field consists only of the
configured priority, but some spanning-tree features might not be available on a given platform (for
example, support for 4096 VLANs). On some platforms, this feature might be mandatory. The first
[chars] is the extended system ID state (enable or disable), and the second [chars] is the
spanning-tree instance.
Recommended Action No action is required.
Error Message SPANTREE-5-ROOTCHANGE: Root Changed for [chars] [dec]: New Root Port
is [chars]. New Root Mac Address is [enet].
Explanation This message means that the root switch changed for a spanning-tree instance. The first
[chars] and [dec] is the interface ID for the previous root port, the second [chars] is the interface ID
for the new root port, and [enet] is the Ethernet address of the new root port.
Recommended Action No action is required.
Error Message SPANTREE-5-TOPOTRAP: Topology Change Trap for [chars] [dec].
Explanation This message means that a trap was generated because of a topology change in the
network.
Recommended Action No action is required.
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Explanation This message means that the interface has been added to all VLANs. [chars] is the added
interface.
Recommended Action No action is required.