Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-63
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
SW_VLAN Messages
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message SW_VLAN-4-BAD_STARTUP_VLAN_CONFIG_FILE: Failed to configure VLAN from
startup-config. Fallback to use VLAN configuration file from non-volatile memory.
Explanation This message means that the VLAN software did not use the VLAN configuration from
the startup-configuration file. It will use the binary VLAN configuration file in NVRAM.
Recommended Action No action is required.
Error Message SW_VLAN-4-BAD_VLAN_CONFIGURATION_FILE: VLAN configuration file
contained incorrect verification word [hex].
Explanation This message means that the VLAN configuration file read by the VLAN manager did
not begin with the correct value. The VLAN configuration file is invalid, and it has been rejected.
[hex] is the incorrect verification value.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command. Copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message SW_VLAN-4-BAD_VLAN_CONFIGURATION_FILE_VERSION: VLAN configuration
file contained unknown file version [dec].
Explanation This message means that the VLAN configuration file read by the VLAN manager
contained an unrecognized file version number, which might mean an attempt to regress to an older
version of the VLAN manager software. [dec] is the file version number.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command. Copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.