Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-67
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
SW_VLAN Messages
Error Message SW_VLAN-4-VTP_USER_NOTIFICATION: VTP protocol user notification:
[chars].
Explanation This message means that the VTP code encountered an unusual diagnostic situation.
[chars] is a description of the situation.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command. Copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message SW_VLAN-6-OLD_CONFIG_FILE_READ: Old version [dec] VLAN configuration
file detected and read OK. Version [dec] files will be written in the future.
Explanation This message means that the VLAN software detected an old version of the VLAN
configuration file format. It interpreted the file, but it will use the new format in the future. The first
[dec] is the old version number, and the second [dec] is the new version number.
Recommended Action No action is required.
Error Message SW_VLAN-6-VLAN_DAT_CACHE_EXISTS: Unexpected vlan.dat cache exists.
Removing the cache and continuing the sync with new set.
Explanation This message means that the switch functionality is unaffected.
Recommended Action No action is required.
Error Message SW_VLAN-3-VLAN_DAT_CACHE_SEQUENCE: Out of sequence vlan.dat sync
message. Expected: [dec]; received: [dec].
Explanation This message means that the vlan.dat file is synchronized to the STANDBY through one
or more checkpoint messages from ACTIVE. The sequence number for each set of checkpoint
messages starts with 1. These messages are cached at the STANDBY until the end-of-set indicator
is received. The STANDBY received a checkpoint message with a sequence number that does not
match the expected sequence number. The first [dec] is the expected checkpoint message sequence
number, and the second [dec] is the received checkpoint message sequence number.
Recommended Action If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about the online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to [chars].
Explanation This message means that the VTP domain name was changed through the configuration
to the name specified in the message. [chars] is the changed domain name.
Recommended Action No action is required.