Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-71
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
UFAST_MCAST_SW Messages
Error Message UDLD-6-UDLD_PORT_RESET: UDLD reset interface [chars].
Explanation This message means that the UDLD Protocol detected a unidirectional connection
between neighbors. Reset the port that was disabled by UDLD by using the udld reset privileged
EXEC command or through a hardware action such as a link-state change. [chars] is the interface.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command. Copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar
reported problems. If you still require assistance, contact HP technical support and provide the
representative with the gathered information. For more information about these online tools and about
contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
UFAST_MCAST_SW Messages
This section contains UplinkFast (UFAST) packet transmission messages.
Error Message UFAST_MCAST_SW-3-PROC_START_ERROR: No process available for
transmitting UplinkFast packets.
Explanation This message means that UplinkFast packets will not be sent because the process could
not be created.
Recommended Action UplinkFast does not work unless you reload the switch software. If this
problem persists even after reload, find out more about the error by using the show tech-support
privileged EXEC command. Copy the message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit
to look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about these online tools
and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE: No memory is available for
transmitting UplinkFast packets on Vlan [dec].
Explanation This message means that UplinkFast packets will not be sent on a VLAN due to memory
limitations. [dec] is the VLAN ID.
Recommended Action Reduce other system activity to ease memory demands.