Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem System Message Guide

2-72
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem System Message Guide
380260-004
Chapter 2 Message and Recovery Procedures
VQPCLIENT Messages
VQPCLIENT Messages
This section contains VLAN Query Protocol (VQP) client messages.
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.
Explanation This message means that an error occurred when the system tried to allocate memory
for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the
“Error Message Traceback Reports” section on page 1-5.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].
Explanation This message means that the VMPS has denied access for the given host MAC address
to an interface. [enet] is the host MAC address, and [chars] is the interface name.
Recommended Action No action is normally required. If you think that the host should have been
allowed access, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Explanation This message means that the system has shut down the specified interface because too
many hosts have requested access to that interface. [chars] is the interface name.
Recommended Action To enable the interface, remove the excess hosts, and enter the no shutdown
interface configuration command.
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Explanation This message means that the VMPS has specified an unknown VLAN name. [chars] is
the VLAN name.
Recommended Action Verify the VMPS configuration.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN [chars] in response.
Explanation This message means that the VMPS has specified an unknown VLAN name. [chars] is
the VLAN name.
Recommended Action Ensure that the VLAN exists on the switch. Verify the VMPS configuration by
entering the show vmps privileged EXEC command.