Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
Table Of Contents
- Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
- Contents
- System Requirements
- Upgrading the Switch Software
- Installation Notes
- New Features
- Minimum Cisco IOS Release for Major Features
- Limitations and Restrictions
- Important Notes
- Open Caveats
- Resolved Caveats
- Documentation Updates
- Updates to the Software Documentation
- Update to the “Configuring IP Unicast Routing” Chapter
- User Interface for VRF-Aware RADIUS
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring Embedded Event Manager” Chapter
- Update to the “Configuring MSTP” Chapter
- Updates to the Switch Getting Started Guide
- Updates for the System Message Guide
- Updates to the Software Documentation
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
20
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
OL-21144-02
Open Caveats
Open Caveats
• CSCsy85676
When you configure an ACL and enter the access-group interface configuration command to apply
it to an interface for web authentication, the output from the show epm session ip-address or show
ip access_list interface interface-id privileged EXEC command does not show any web
authentication filter ID.
There is no workaround.
• CSCsz18634
On a switch running Cisco IOS release 12.2(46)SE, the output of the show interfaces privileged
EXEC command shows 0 packets for port channel input and output rates.
The workaround is to reload the switch by entering the reload privileged EXEC command.
• CSCta72141
The bootloader label is incorrect and displays “CISCO DEVELOPMENT TEST VERSION.”
However, the actual bootloader software is the correct version with the correct functionality.
There is no workaround. It does not impact functionality.
• CSCtb08823
SNMP requests on the stpxRSTPPortRoleTable object only return information for the stack master.
There is no workaround.
• CSCtb25230
When a switch stack is configured with DHCP snooping enabled on the host VLAN, hosts connected
to the stack master receive bootp packets, but the a packet might not be forwarded to the end hosts
connected to stack member switches. The behavior depends on which interface in the stack received
the packet.
The workaround is to disable DHCP snooping for the affected VLAN.
• CSCtc02635
On switches running Cisco IOS release 12.2(50)SE3 running MAC authentication bypass with
multidomain authentication (MDA, IP phones connected to a port might not be able to regain
network connectivity in the VOICE domain if the session times out and all RADIUS servers are
unreachable.
There is no workaround.
• CSCtd29049
A switch that has at least one trunk port configured might fail when you configure more than 950
VLANS by using the vlan vlan-id global configuration command.
There is no workaround.
Resolved Caveats
• Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(53)SE1, page 21
• Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(53)SE, page 22