Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
Table Of Contents
- Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
- Contents
- System Requirements
- Upgrading the Switch Software
- Installation Notes
- New Features
- Minimum Cisco IOS Release for Major Features
- Limitations and Restrictions
- Important Notes
- Open Caveats
- Resolved Caveats
- Documentation Updates
- Updates to the Software Documentation
- Update to the “Configuring IP Unicast Routing” Chapter
- User Interface for VRF-Aware RADIUS
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring Embedded Event Manager” Chapter
- Update to the “Configuring MSTP” Chapter
- Updates to the Switch Getting Started Guide
- Updates for the System Message Guide
- Updates to the Software Documentation
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
23
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
OL-21144-02
Documentation Updates
• CSCtc30872
When a BPDU guard is globally enabled on a switch and the access VLAN is a VLAN other than
VLAN 1, BPDU guard does not run on a multiple VLAN access port.
The workaround is to enable BPDU guard on the port.
• CSCtc57809
When the no mac address-table static mac-addr vlan vlan-id interface interface-id global
configuration command is used to remove a dynamically learned MAC address, the switch fails
under these conditions:
–
The physical interface is in a no shut state.
–
The MAC address is first dynamically learned and then changed to static.
There is no workaround.
• CSCtd31242
An IP phone loses network connectivity under these conditions:
–
The IP phone is authenticated by MAB (in Open1x mode) on a supplicant switch.
–
The supplicant switch is connected to an authenticator switch through the NEAT protocol.
A call is placed using the IP phone. After approximately 5 minutes, network connectivity to the
phone is lost.
The workaround is to statically configure the MAC address of the IP phone on the authenticator
switch.
• CSCtd72456
After you have entered the snmp-server host informs global configuration command to enable
SNMP informs on a switch, the switch might fail if you enter the show snmp pending user EXEC
command.
There is no workaround. Do not enter the show command when SNMP informs are enabled.
Documentation Updates
• Updates to the Software Documentation, page 24
• Updates to the Switch Getting Started Guide, page 26
• Updates to the Switch Getting Started Guide, page 26
• Updates for the System Message Guide, page 26