Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later

28
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
OL-21144-02
Documentation Updates
Error Message DOT1X_SWITCH-5-ERR_PRIMARY_VLAN_NOT_FOUND: Attempt to assign VLAN
[dec], whose primary VLAN does not exist or is shutdown, to 802.1x port [chars]
AuditSessionID [chars]
Explanation
An attempt was made to assign a private VLAN whose primary VLAN does not exist or
is shut down. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.
Recommended Action Make sure the primary VLAN exists and is not shut down. Verify that the
private VLAN is associated with a primary VLAN.
Error Message DOT1X_SWITCH-5-ERR_SEC_VLAN_INVALID: Attempt to assign secondary VLAN
[dec] to non-PVLAN host 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign a secondary VLAN to a port that is not a private VLAN
host port, which is not allowed. [dec] is the VLAN, the first [chars] is the port, and the second [chars]
is the session ID.
Recommended Action Change the mode of the port so that it is configured as a private VLAN host
port, or use a different VLAN that is not configured as a secondary VLAN.
Error Message DOT1X_SWITCH-5-ERR_SPAN_DST_PORT: Attempt to assign VLAN [dec] to
802.1x port [chars], which is configured as a SPAN destination AuditSessionID
[chars]
Explanation
An attempt was made to assign a VLAN to an IEEE 802.1x port that is configured as a
Switched Port Analyzer (SPAN) destination port. [dec] is the VLAN, the first [chars] is the port, and
the second [chars] is the session ID.
Recommended Action Change the SPAN configuration so that the port is no longer a SPAN
destination port, or change the configuration so that no VLAN is assigned.
Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_MDA_INACTIVE: Multi-Domain Authentication
cannot activate because Data and Voice VLANs are the same on port AuditSessionID
[chars]
Explanation
Multi-Domain Authentication (MDA) host mode cannot start if the configured data
VLAN on a port is the same as the voice VLAN. [chars] is the port session ID.
Recommended Action Change either the voice VLAN or the access VLAN on the interface so that
they are not the same. MDA then starts.
Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_VVLAN: Data VLAN [dec] on port [chars]
cannot be equivalent to the Voice VLAN AuditSessionID [chars]
Explanation
An attempt was made to assign a data VLAN to an IEEE 802.1x port that is the same as
the voice VLAN. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session
ID.
Recommended Action Change either the voice VLAN or the IEEE 802.1x-assigned VLAN on the
interface so that they are not the same.