Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
Table Of Contents
- Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
- Contents
- System Requirements
- Upgrading the Switch Software
- Installation Notes
- New Features
- Minimum Cisco IOS Release for Major Features
- Limitations and Restrictions
- Important Notes
- Open Caveats
- Resolved Caveats
- Documentation Updates
- Updates to the Software Documentation
- Update to the “Configuring IP Unicast Routing” Chapter
- User Interface for VRF-Aware RADIUS
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring IEEE 802.1x Port-Based Authentication” Chapter
- Update to the “Configuring Embedded Event Manager” Chapter
- Update to the “Configuring MSTP” Chapter
- Updates to the Switch Getting Started Guide
- Updates for the System Message Guide
- Updates to the Software Documentation
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
![](/manual/hp/cisco-catalyst-1-10gbe-3120x-blade-switch/release-notes-for-cisco-catalyst-blade-switch-3120-for-hp-cisco-ios-release-12253se-and-later/images/img-29.png)
29
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(53)SE and Later
OL-21144-02
Documentation Updates
Error Message DOT1X_SWITCH-5-ERR_VLAN_INTERNAL: Attempt to assign internal VLAN
[dec] to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
specified is used internally and cannot be assigned to this port. [dec] is the VLAN, the first [chars]
is the port, and the second [chars] is the session ID.
Explanation Assign a different VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INVALID: Attempt to assign invalid VLAN [dec]
to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
specified is out of range. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is
the session ID.
Recommended Action Update the configuration to use a valid VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_NOT_FOUND: Attempt to assign non-existent or
shutdown VLAN [chars] to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign a VLAN to an IEEE 802.1x port, but the VLAN was not
found in the VLAN Trunking Protocol (VTP) database. [dec] is the VLAN, the first [chars] is the
port, and the second [chars] is the session ID.
Recommended Action Make sure the VLAN exists and is not shutdown or use another VLAN.
These messages have been deleted:
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the 802.1X
action.
Explanation
The system memory is not sufficient to perform the IEEE 802.1x authentication.
Recommended Action Reduce other system activity to reduce memory demands.
Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on
Interface [chars]
Explanation
Authentication was successful. [chars] is the interface.
Recommended Action No action is required.