Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide, Rel. 12.2(25)SEF1

27-59
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-01
Chapter 27 Configuring QoS
Configuring Standard QoS
Switch(config-pmap)# exit
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy input aggflow1
Switch(config-if)# exit
Configuring DSCP Maps
These sections contain this configuration information:
• Configuring the CoS-to-DSCP Map, page 27-59 (optional)
• Configuring the IP-Precedence-to-DSCP Map, page 27-60 (optional)
• Configuring the Policed-DSCP Map, page 27-61 (optional, unless the null settings in the map are
not appropriate)
• Configuring the DSCP-to-CoS Map, page 27-62 (optional)
• Configuring the DSCP-to-DSCP-Mutation Map, page 27-63 (optional, unless the null settings in the
map are not appropriate)
All the maps, except the DSCP-to-DSCP-mutation map, are globally defined and are applied to all ports.
Configuring the CoS-to-DSCP Map
You use the CoS-to-DSCP map to map CoS values in incoming packets to a DSCP value that QoS uses
internally to represent the priority of the traffic.
Table 27-12 shows the default CoS-to-DSCP map.
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the CoS-to-DSCP map. This
procedure is optional.
Table 27-12 Default CoS-to-DSCP Map
CoS Value DSCP Value
00
18
216
324
432
540
648
756