Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 15.0(2)SE and Later

OL-27324-02

Important Notes

Device Manager Limitations

• When you are prompted to accept the security certificate and you click No, you only see a blank

screen, and the device manager does not start.

The workaround is to click Yes when you are prompted to accept the certificate. (CSCef45718)

• When the physical UID LED of the switch is on, it is blue. However, when the image of this LED

on the device manager Front Panel view is on, it is green.

There is no workaround (CSCsd98457).

Important Notes

Note Beginning with Cisco IOS Release 12.2(58)SE, the software configuration guide no longer includes a

MIB appendix. To locate and download MIBs for a specific Cisco product and release, use the Cisco

MIB Locator:



‘http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.

• “Cisco IOS Notes” section on page 11

• “Device Manager Notes” section on page 12

Cisco IOS Notes

• The behavior of the no logging on global configuration command changed in Cisco IOS

Release

12.2(18)SE and later. You can only use the logging on and then the no logging console

global configuration commands to disable logging to the console. (CSCec71490)

• In Cisco IOS Release 12.2(25)SEC, the implementation for multiple spanning tree (MST) changed

from the previous release. Multiple STP (MSTP) complies with the IEEE 802.1s standard. Previous

MSTP implementations were based on a draft of the IEEE 802.1s standard.

• If the switch requests information from the Cisco Secure Access Control Server (ACS) and the

message exchange times out because the server does not respond, a message similar to this appears:

00:02:57: %RADIUS-4-RADIUS_DEAD: RADIUS server 172.20.246.206:1645,1646 is not

responding.

If this message appears, make sure that there is network connectivity between the switch and the

ACS. You should also make sure that the switch has been properly configured as an AAA client on

the ACS.

• Cisco IOS Release 12.2(40)SE and later

If the switch has interfaces with automatic QoS for voice over IP (VoIP) configured and you upgrade

the switch software to Cisco IOS Release 12.2(40)SE (or later), when you enter the auto qos voip

cisco-phone interface configuration command on another interface, you might see this message:

AutoQoS Error: ciscophone input service policy was not properly applied

policy map AutoQoS-Police-CiscoPhone not configured

If this happens, enter the no auto qos voip cisco-phone interface command on all interface with

this configuration to delete it. Then enter the auto qos voip cisco-phone command on each of these

interfaces to reapply the configuration.