Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.0(4d) (OL-21012-06 B0, May 2011)

Send documentation comments to [e-mail]
37
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.0(4d)
OL-21012-06
Caveats
!---
ip access-list 150 deny udp any any eq port snmp
ip access-list 150 deny tcp any any eq port snmp
!---
!--- Permit/deny all other Layer 3 and Layer 4 traffic in
!--- accordance with existing security policies and
!--- configurations. Permit all other traffic to transit the
!--- device.
!---
access-list 150 permit ip any any
!--- Apply access-list to management interface
interface serial 2/0
ip access-group 150 in
For more information on IP Access Control Lists see the “Configuring IPv4 and IPv6 Access
Control List” section in the Cisco MDS 9000 Family NX-OS Security Configuration Guide at the
following location:
http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/sec/
nxos/ipacl.html
For more information on IP Access Control Lists see the “Configuring ACLs” section in the Cisco
Nexus 5000 Series NX-OS Software Configuration Guide at the following location:
http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli_rel_
4_0_1a/sec_ipacls.html
Workaround: This issue is resolved.
• CSCto62199
Symptom: The MDS 9222i switch spontaneously reboots itself. The output of the show system
exception command includes the following stack trace output:
STACK
Call Trace:
[<f724ebf4>]str_isr_handle_cpm_one_intr_reg+0x94/0x310 [klm_str]
[<f724f4dc>]str_isr_cpm_0to3+0xf8/0x154 [klm_str]
[<f72510c0>]str_isr_bh+0x1bc/0x218 [klm_str]
[<c004cf50>]worker_thread+0x17c/0x228
[<c0052a8c>]kthread+0xec/0x128
[<c001bdf0>]original_kernel_thread+0x44/0x60
Workaround: This issue is resolved.
Open Caveats
• CSCtn72391
Symptom: Following a switch reload or a software upgrade, the startup configuration occasionally
does not display feature fcip.
Workaround: Once the switch is completely up, copy the running configuration to the startup
configuration by entering the copy running-config startup-config command.
• CSCtn68418
Symptom: When you try to save a configuration, you might see the following message:
switch# copy run start
[########################################] 100%