Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

C-5
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Appendix C Cable and Port Specifications
MGMT 10/100/1000 Ethernet Port
Table C-5 lists the pinouts for the COM1 port, the DB-9F/RJ-45F PC terminal, RJ-45 rollover cable, and
the RJ-45/DSUB R/P adapter.
MGMT 10/100/1000 Ethernet Port
The MGMT 10/100/1000 Ethernet port is an Ethernet port with an RJ-45 connector. You can use a
modular, RJ-45, straight-through UTP cable to connect the management port to an external hub, switch,
or router (see Figure C-3).
Figure C-1 RJ-45 Interface Cable Connector
Table C-6 lists the connector pinouts and signal names for a 10/100/1000BASE-T management port
(MDI) cable.
Note The RJ-45 interface only uses pins 1, 2, 3, and 6.
Table C-5 Port Mode Signaling and Pinouts for Modem with DB-25 Connection
COM1 Port
DB-9F/RJ45F
PC terminal
RJ-45
Rollover Cable
RJ-45/DSUB R/P
Adapter Modem
Signal DB-9 Pin RJ-45 Pin RJ-45 Pin DB-25 Pin Signal
CTS 8 8 1 5 CTS
DSR 6 7 2 8 DCD
RxD 2 6 3 3 RxD
GND 5 5 4 7 GND
GND 5 4 5 7 GND
TxD 3 3 6 2 TxD
DTR 4 2 7 20 DTR
RTS 7 1 8 4 RTS
1 Pin 1 2 Pin 8
94971
1
2
RJ-45 (both ends)
Table C-6 10/100/1000BASE-T Management Port Cable Pinout (MDI)
Pin Signal
1TD+
2TD-