Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

C-6
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Appendix C Cable and Port Specifications
MGMT 10/100 Ethernet Port
Figure C-2 shows a schematic of the 10/100/1000BASE-T cable required to connect the management
port to a switch or hub (not provided with the switch).
Figure C-2 Twisted-Pair 10/100/1000BASE-T Cable Schematic
MGMT 10/100 Ethernet Port
The MGMT 10/100 Ethernet port is an Ethernet port with an RJ-45 connector. You can use a modular,
RJ-45, straight-through UTP cable to connect the management port to an external hub, switch, or router
(see Figure C-3).
Figure C-3 RJ-45 Interface Cable Connector
3RD+
6RD–
4Not used
5Not used
7Not used
8Not used
Table C-6 10/100/1000BASE-T Management Port Cable Pinout (MDI) (continued)
Pin Signal
1 TXD+
2 TXD-
3 RXD+
6 RXD-
1 RXD+
MGMT 10/100
Switch/Hub
2 RXD-
3 TXD+
6 TXD-
4NC
5NC
7NC
8 NC
4NC
5NC
7NC
8 NC
99343
1 Pin 1 2 Pin 8
94971
1
2
RJ-45 (both ends)