Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(1c) (OL-14116-08, July 2008)

Send documentation comments to [e-mail]
33
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(1c)
OL-14116-08
Caveats
• CSCsq70353
Symptom: The QOS component on a standby Supervisor module looses a small amount of memory
during every port flap. This loss increases over time and may result in the QOS component restarting
on the standby Supervisor module. This affects standby Supervisor modules on MDS 9500 series
switches only. This does not affect active Supervisor modules on MDS 9500 series switches or active
Supervisor modules on fabric switches.
Workaround : This issue is resolved.
• CSCsc67248
Symptom: The SSH key information is not consistent between the CLI and SNMP agent.
Workaround: This issue is resolvled.
• CSCsq24999
Symptom: The FCIP link flaps. This issue can be identified by connecting to the associated module
and issuing the show port-config internal link-events command as shown below.
module-2# show port-config internal link-events
*************** Port Config Link Events Log ***************
---- ------ ----- ----- ------
Time PortNo Speed Event Reason
---- ------ ----- ----- ------
Apr 30 14:21:36 2008 00223659 fcip102 1G UP
Apr 30 14:21:34 2008 00474730 fcip102 --- DOWN Loss Of Signal
Alternatively, look at the eth-trace-logs for the associated Gigabit Ethernet port. On the switch issue
the show ips internal eth-trace-logs gigabitethernet <x/y> command as shown below.
Trace [318] Fri May 9 11:14:40 2008 usec: 00392739
FCIP fcip102:Deleting DE in the lep tcp conn 1 de delete reason: loss of signal tag:
0x0
Trace [319] Fri May 9 11:14:40 2008 usec: 00392739
FCIP :Deleting DE tcp conn 1 terminate de delete reason: loss of signal tag: 0x0
Trace [320] Fri May 9 11:14:40 2008 usec: 00392739
FCIP :Deleting DE Clean up connection 1 de delete reason: loss of signal tag: 0x0
Workaround: This issue is resolved.
• CSCsq27863
Symptom: SME may generate a CHECK CONDITION as a part of the media identification when
the tape is loaded into a STK 9xxx drive if the first block on the tape is greater than 60 KB. The
current interop matrix supports only TSM backup application on STK 9xxx family of drives and this
application does not suffer from this issue.
Workaround: This issue is resolved.
• CSCsq32228
Symptom: The scheduler process fails when configured with a job configuration which generates
more than 5 MB of output (for example, the show tech-support detail command which generates
about 20 MB of output). If the scheduler process fails more than 3 times, then the scheduler process
may not function properly and issuing the copy run start command will fail.
Workaround: This issue is resolved.