Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2) (OL-14116-10 C0, November 2008)

Send documentation comments to mdsfeedback-doc@cisco.com

Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)

OL-14116-10

Caveats

• CSCsr49954

Symptom: The Recoverpoint Appliance with a QLogic HBA sends an 8 byte RFT_ID instead of the

standard 32bytes, which causes FC4 features to be incorrectly registered with all features.

Workaround: This issue is resolved.

• CSCsr53531

Symptom: In IVR NAT environment, after active mode PortChannel flaps, some member of the

PortChannel may not get programmed in the IVR table, so that related IVR traffic will get lost.

Workaround: This issue is resolved.

• CSCsr94621

Symptom: A Fiber Channel over IP (FCIP) trunk can go down if the maximum transmission unit

(MTU in the path is less than the MTU of the MDS Gigabit Ethernet interface.

Workaround: This issue is resolved.

• CSCsr98144

Symptom: If a sync-loss is received for a nonexisting fabric, the xbar-manager transitions to a state

from which it does not exit.

Workaround: This issue is resolved.

• CSCsu06940

Symptom: An Octeon core occurred.

Workaround: This problem is resolved.

• CSCsu31223

Symptom: A slow memory leak has been found as a part of the view of the interface table MIB with

the SME interfaces. This eventually results in the SNMPD process resetting due to lack of memory.

Workaround: This issue is resolved.

• CSCsr02430

Symptom: After issuing the show boot command, there are duplicate image names listed in the switch

output as shown below:

switch# show boot

sup-1

kickstart variable not set

system variable = bootflash:/m9500-sf1ek9-mzg.3.4.1.bin;bootflash:/m9500-sf1ek9-

mzg.3.4.1.bin

sup-2

kickstart variable not set

system variable = bootflash:/m9500-sf1ek9-mzg.3.4.1.bin;bootflash:/m9500-sf1ek9-

mzg.3.4.1.bin

No module boot variable set

switch#

This occurs if you issue the boot system command twice with the same image name as shown below:

switch(config)# boot system bootflash:m9500-sf1ek9-mzg.3.4.1.bin

Workaround: This issue is resolved.

• CSCsq64637

Symptom: All device aliases in Fabric Manager disappear when adding new device aliases.