HP StorageWorks C-Series Fabric Switches for SAN-OS 3.2(3) and FabricWare 2.1(3) Release Notes ( AA-RWEHK-TE, January 2008)

9 MDS Multilayer Director & Multilayer Fabric Switches Release Notes
• If the display shows inorder delivery: guaranteed, in-order delivery of
frames is enabled and no other steps are required
• If the display shows
inorder delivery: not guaranteed, in-order delivery of
frames is disabled; continue to the next step
5. Enter into the configuration mode by entering the following command:
switch# config terminal
6. Enter the following command to set in-order delivery of frames:
switch(config)# in-order-guarantee
switch(config)# exit
7. Enter the following command to verify that in-order delivery is enabled:
switch# show in-order-guarantee
You should see the following response for all VSANs:
inorder delivery: guaranteed
8. Copy the running configuration into the startup configuration by entering the
following:
switch# copy running-config startup-config
Note: The running configuration overwrites the startup configuration.
IOD must be enabled for any additional VSANs created.
Refer to the Cisco MDS 9000 Family Fabric Manager Switch Configuration Guide to
enable IOD using Device/Fabric Manager.
Fabric Manager & Device Manager GUI Setup
The optional Cisco Fabric/Device Manager GUI (graphical user interface) is a Java application.
The Fabric/Device Manager installation process is based on requirements for installing Java Web
Start. Refer to the Cisco MDS 9000 Fabric Manager Release Notes for system requirements and
installation instructions.
To install Device Manager, use a web browser to make an http:// connection to the IP address of a
C-Series switch.
Note:
Device Manager cannot be installed from the MDS 9020.
Starting with SAN-OS 3.2(1a), Fabric Manager is no longer embedded in the SAN-OS software.
Fabric Manager is available from a CD-ROM or provided by HP in the SAN-OS image bundle.
For additional information on how to install Fabric Manager refer to the “Installation of Cisco
MDS SAN-OS and Fabric Manager” section in the Cisco MDS 9000 Family Fabric Manager
Configuration Guide.
Note: The MDS 9020 currently runs FabricWare 2.1(3); HP recommends using the latest
supported Fabric/Device Manager when managing this switch via the GUI.