Cisco MDS 9000 Family Storage Media Encryption Configuration Guide - Release 4.x (OL-18091-01, February 2009)

Send documentation comments to [e-mail]
5-14
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
OL-18091-01, Cisco MDS NX-OS Release 4.x
Chapter 5 Cisco SME Tape Configuration
Adding Tape Volume Groups
Adding Tape Volume Groups
To add tape volume groups to an existing tape group, follow these steps:
Step 1 Click Volume Groups. Click Create.
Step 2 Enter the new volume group name and configure a filter that Cisco SME will use to match volumes for
that volume group. Select from the following:
• None—Used only if you want to import volume groups into another volume group (see Importing
Volume Groups, page 6-12).
• Regex—Cisco SME will place the volume if the barcode matches the expression.
• Ranges—Cisco SME will place the volume within a specific barcode range.
Note Overlapping ranges are not recommended. If there are overlapping ranges, then Cisco SME places the
volume based on the lexicographic ordering of the volume group.
Note If there is not a direct match, then the volumes will be placed in the default volume group.