Cisco MDS 9000 Family Storage Media Encryption Configuration Guide - Release 4.x (OL-18091-01, February 2009)

Send documentation comments to [e-mail]
7-5
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
OL-18091-01, Cisco MDS NX-OS Release 4.x
Chapter 7 Using the Command Line Interface to Configure SME
Setting Up the Cisco SME Administrator and Recovery Officer Roles
Setting Up the Cisco SME Administrator and Recovery Officer
Roles
To set up the Cisco SME Administrator, Cisco SME Storage Administrator, Cisco SME KMC
Administrator and Cisco SME Recovery Officer follow this step:
Adding an SME Interface from a Local or Remote Switch
Before adding an SME interface, be sure to enable clustering, enable Cisco SME, and start the Cisco
SME interface on the switch, and then add the interface to the cluster.
To add an SME interface from a local switch, follow these steps:
To add an SME interface from a remote switch, follow these steps:
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Specifies the cluster and enters SME cluster configuration
submode.
Step 3
switch(config-sme-cl)# security-mode
basic
Sets the cluster security level to Basic.
Command Purpose
Command Purpose
Step 1
switch# setup sme
Sets up the four security roles.
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Specifies the cluster and enters SME cluster configuration
submode.
Step 3
switch(config-sme-cl)# fabric
clustername1
Specifies the fabric.
Step 4
switch(config-sme-cl)# node local
switch(config-sme-cl-node)#
Enters the SME cluster node submode and specifies the
local switch.
Step 5
switch(config-sme-cl-node)#
fabric-membership clustername1
Specifies the fabric membership for the cluster.
Step 6
switch(config-sme-cl-node)#
interface sme 4/1 force
Adds the SME interface (4/1) from a local switch in fabric
f1.
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Specifies the cluster and enters SME cluster configuration
submode.