Cisco MDS 9000 Family Storage Media Encryption Configuration Guide - Release 4.x (OL-18091-01, February 2009)

Send documentation comments to [e-mail]
7-11
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
OL-18091-01, Cisco MDS NX-OS Release 4.x
Chapter 7 Using the Command Line Interface to Configure SME
Viewing Cisco SME Cluster, Internal, and Transport Information
Viewing Tape Information
Use the show sme cluster tape command to view summary or detailed information about tapes.
switch# show sme cluster clustername1 tape summary
-------------------------------------------------------------------------------
Host WWN Description Crypto-Tape Status
Backup Group
-------------------------------------------------------------------------------
10:00:00:00:c9:4e:19:ed HP Ultrium 2-SCSI HR1 online
Viewing Tape Cartridge Information
Use the show sme cluster tape detail to view information about tape cartridges.
switch# show sme cluster clustername1 tape detail
Tape 1 is online
Is a Tape Drive
HP Ultrium 2-SCSI
Serial Number is 2b10c2e22f
Is a member of HR1
Paths
Host 10:00:00:00:c9:4e:19:ed Target 2f:ff:00:06:2b:10:c2:e2 LUN 0x0000
Viewing Tape Volume Group Information
Use the show sme cluster tape-bkgrp command to view information about all tape volume groups or
about a specific group.
switch# show sme cluster clustername1 tape-bkgrp
-------------------------------------------------------------------------------
Name Tape Devices Volume Groups
-------------------------------------------------------------------------------
HR1 1 1
switch# show sme cluster clustername1 tape-bkgrp HR1
Tape Backupgroup HR1
Compression is Disabled
Number of tape devices is 1
Number of volume groups is 1
Tape device td1 is online
Is a tape drive
Description is HP Ultrium 2-SCSI
Serial number is 2b10c2e22f
Paths
Host 10:00:00:00:c9:4e:19:ed Target 2f:ff:00:06:2b:10:c2:e2 Lun 0x0000 vsan 4093[f1]
Viewing Cisco SME Role Configurations
Use the setup sme command to set up the four roles for Cisco SME, and then use the show role
command to view the various Cisco SME role configurations.
switch(config)# setup sme
Set up four roles necessary for SME, sme-admin, sme-stg-admin, sme-kmc-admin and
sme-recovery? (yes/no) [no] yes
If CFS is enabled, please commit the roles so that they can be available.