Cisco MDS 9000 Family Storage Media Encryption Configuration Guide - Release 4.x (OL-18091-01, February 2009)
Send documentation comments to mdsfeedback-doc@cisco.com
4-16
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
OL-18091-01, Cisco MDS NX-OS Release 4.x
Chapter 4 Cisco SME Cluster Management
Creating a Cisco SME Cluster Using the Cisco SME Wizard
Step 2 A Store Keyshares screen opens. After the smart card applet finishes loading, click Next.
When entering smart card information, note the following:
• Be sure that the smart card reader is connected using the USB port (see the “Installing Smart Card
Drivers” section on page 2-17 in Chapter 2, “Getting Started”).
• When you insert a smart card into the reader, the card will be verified. You will be prompted to
initialize the card if the card has not been previously initialized.
• For each smart card, each Cisco SME Recovery Officer must login and enter the smart card pin.
• Make sure that you have the correct smart card drivers installed before proceeding.
Step 3 Enter the switch login information (username and password used to log in to Fabric Manager), the PIN
number for the smart card, and a label that will identify the smart card. The PIN number and label were
defined during the smart card initialization. Click Next.